Whirlpool MK1074XHQ Installation Instructions Manual page 2

STEP 1
Disconnect power before installing trim kit.
Replace all panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect the microwave oven before
proceeding with installation.
2. Remove any loose items inside the microwave
oven.
3. Fasten the bottom brackets to the bottom duct
by using eight 1/2
4. Remove two existing screws from the right and
left side of microwave cabinet.
(1 screw each side)
5. Install the bottom duct with one existing screw
to the right side of microwave oven as shown.
STEP 2
1. Connect the side duct to the upper duct as shown.
a) Insert projecting tabs of the upper duct into holes of the side duct.
b) Bend tabs up as shown.
NOTE: Remove any oil or dirt on surface of microwave oven before ducts are attached.
= 
6 tabs
2. Peel off the backing of double sided tape. Using
the left side screw holes as a guide, attach the side
duct and upper duct assembly on the microwave
cabinet. Press down firmly on ducts. Fasten duct
assembly to left side of cabinet with one existing
screw.
Electrical Shock Hazard
"
screws.
Upper Duct
WARNING
1 /2" Screws (8)
REAR
FRONT VIEW OF
MICROWAVE
6 Holes
Side Duct
Existing screw (1)
> 
FRONT
Existing
Screw (1)