Craftsman MONSTER 486.245071 Operator's Manual page 13

CART COvER ASSEMBLY
•
Slide the front support tube through the double loops
located near the front of the cart cover. See figure 14.
DOUBLE LOOPS
FRONT
SUPPORT
TUBE
FIGURE 14
•
Slide the front (straight) support rod through the
center loop (located in the top of the cart cover)
closest to the front of the bag. Slide a lower support
rod (bent) through the center loop behind the front
rod. See figure 15.
CENTER LOOP
FRONT
SUPPORT
LOWER
ROD
SUPPORT
ROD
FIGURE 15
CART COVER
CENTER LOOP
CART COVER
•
Slide the second lower support rod through outer
edge of the cart cover. Slide an end of the rope onto
the rod end as it approaches each gap in edge. The
bend in the rod must face in the direction shown in
figure 16.
CART COVER
BEND
FIGURE 16
• Secure front support tube to top angle support
using two 1/4" x 1-1/4" hex bolts and 1/4" lock nuts.
TIGHTEN. Do not over tighten and collapse support
tube. See figure 17.
NOTE: Cart bag not shown for clarity.
1/4" x 1-1/4" HEX BOLT
FIGURE 17
13
ROPE
SUPPORT ROD
1/4" LOCK NUT