Create STEAM CLEANER MOP User Manual page 8

Use of accessories
• Jet nozzle installation: Align the powerful nozzle with the air outlet head at the front of the main unit,
then rotate it until the power nozzle is firmly attached to the machine.
• Install the powerful nozzle brush: Put the small brush on the powerful nozzle. Note that the direction of
the elbow of the small brush is as shown in the picture below, otherwise the direction of the installed
brush is not good.
• After confirming that the power supply is correct, plug in the power supply, the power indicator light is
on, and the machine starts to heat up.
• The light will be blinking and after about 25 seconds, the indicator light will stay on. At this point, press
the steam switch and the steam will be ejected immediately.
• According to different cleaning requirements, you can adjust the "+" and "-" buttons on the control panel
until you reach the size of the steam you want. At any time, you can adjust the effect of steaming through
the adjustment control on the main unit.
Note: Do not aim the steam at pets, plants or any other electrical appliances during use to avoid burns or
damage to the machine.
• Installation extension rod: When it is necessary to clean high, far places or mopping the floor, there is
an extension rod specially designed for this machine. It is also used to align the extension rod with the
head of the machine, then push it on the head of the main machine, then gently rotate the extension rod
firmly on the main unit.
• In the same way, the mop head can be connected with the extension rod, and the extension rod can be
connected with the powerful nozzle.
8 E NGL ISH