Toshiba Satellite L640-BT2N13 Resource Manual page 22

22
Using the optical disc drive
off. Use a straightened paper clip or other narrow object to press the
manual eject button located inside the hole.
Inserting an optical disc
1 Make sure the computer is turned on and the drive's in-use
indicator light is off.
2 If you have a tray-type drive, press the drive's eject button to
eject the disc tray. After the tray slides partially out of the
drive, grasp the tray and pull it fully open.
3 Hold the disc by its edges and check that it is clean and free of
dust.
4 Insert the disk into the drive according to the instructions
below for your drive type.
(Sample Illustration) Positioning the disc in a tray-type drive
Never use a pencil to press the manual eject button. Pencil lead can
break off inside the computer and damage it.
Handle DVDs and CDs carefully, making contact only with the center
hole and edge. Do not touch the surface of the disc. Do not stack
discs. If you incorrectly handle the discs, you could lose data.
Tray-type drive: With the label facing up, gently press the
disc onto the center spindle until it clicks into place. Make
sure the disc is completely on the spindle and is lying flat
on the tray. Then, push the disc tray in by pressing gently
on the center of the tray until it clicks into place.
If you insert the disc incorrectly, it may jam the drive. If this happens,
contact Toshiba support for assistance.