Seecode 235807 Manual page 8

Features of the unit
1. high suction power
2. lithium battery operation allows cordless use at home and in the car
3. the dust container has a large capacity of 700 ml
4. double layer filter system, dry and wet
5. adapter for quick charging
6. lighting function
Operating the hand vacuum cleaner
1. Before using the SEECODE cordless hand hoover for the first time,
it should be fully charged.The green light indicates that the unit is
fully charged and the red light on the power adapter indicates that the
product is charging.
2. Remove the protective cap on the slider. To switch on the hoover with
the lower level 1, slide the switch forward. For the higher level 2 suction
power, slide the switch backwards.
3. Suction tubes / brushes:
Insert the end of one of the suction tubes or one of the brushes into the
inlet of the dust container of the hoover, depending on the desired area
of application. The flexible hose can be used to extend the range of
application of each of the attachments.
Help with decreasing suction power:
Please empty the dust container. To do this, hold the dust container and press
the release button on the top of the appliance. Before pulling the pre-filter
off the dust container, remember its position. Pull the rubber frame with the
pre-filter off the dust container and empty the dust container.
Then put the pre-filter back into the dust container. Make sure that the
pre-filter is in the correct position and that the contact surfaces between the
pre-filter and the dust container are clean.
8