BMW SEDAN 5 Series Owner's Manual page 40

CONTROLS
▷ After several minutes, if no operation takes
place on the vehicle.
▷ If the charge state of the vehicle battery is
low.
▷ Depending on the configuration via iDrive:
one or both front doors will be opened after
driving when exiting the vehicle.
In some situations, the idle state is not set auto‐
matically, for instance during a phone call or
when the low beams are switched on.
Establishing idle state when
opening the front doors
After a trip, the sleep mode can be established
by opening the front doors. For this purpose, the
driver and front passenger must exit the vehicle.
1. "CAR"
2. "Settings"
3. "Doors/ vehicle access"
4. "Turn off vehicle after opening door"
Manual idle state
To establish idle state in the vehicle after com‐
pletion of trip:
Press and hold the button on the
radio until the OFF indicator on
the instrument cluster goes out.
Standby state
Principle
When standby state is switched on, most func‐
tions can be used while the vehicle is stationary.
Desired settings can be adjusted.
General information
The vehicle is in the standby state after the front
doors are opened from the outside.
40
Operating state of the vehicle
Online Edition for Part no. 01405A48957 - X/21
Standby, manual
General information
Standby can be switched back on after the vehi‐
cle is automatically set to idle state.
Via button on the radio
Press the button on the radio.
The control display and the in‐
strument cluster illuminate.
Via start/stop button
Press the Start/Stop button. The
control display and the instrument
cluster illuminate.
Display in the instrument cluster
OFF is displayed in the instru‐
ment cluster. The drivetrain is
switched off and standby state
switched on.
Drive readiness
Principle
Turning on drive-ready state corresponds to
starting the engine.
General information
Some functions, such as DSC Dynamic Stability
Control, can only be used with drive-ready state
switched on.