Table of Contents
Advertisement
2. Pull the plastic connection out and drain
the water into a basin or equivalent
receptacle.
3. Push the plastic connection back in and
place the water container back into
position.
4. To continue the programme press the
Start/Pause button.
10.3 Cleaning the condenser
Heat exchanger flashes on
If the symbol
the display, inspect the condenser and its
compartment. If it is dirty, clean it. Do the
check not less than once a 6 months.
WARNING!
Do not touch the metal surface with bare
hands. Risk of injury. Wear protective
gloves. Clean carefully to avoid
damaging the metal surface.
To inspect:
1. Open the door. Pull the filter up.
22
ENGLISH
2. Open the condenser cover.
3. Turn the lever to unlock the condenser
lid.
4. Lower the condenser lid.
5. If necessary, remove the fluff from the
condenser and its compartment. You can
use a vacuum cleaner with the brush
attachment.
6. Close the condenser lid.
7. Turn the lever until it clicks into position.
8. Put the filter back.
Advertisement
Table of Contents
