Maintaining And Cleaning The Device - Waeco Refresh-o-mat HD Operating Manual

Refresh-o-mat HD
Use the Refresh-o-mat to clean the outer air ducts as described in the
chapter "Cleaning the air-conditioning unit" on page 12.
1. Set air-conditioning system to outer air mode (4) (fig. 8, page 4).
2. Place the Refresh-o-mat in front of the vehicle.
3. Connect the adapter kit to the Refresh-o-mat. Place the end of the
adapter kit in front of the outer air ducts (fig. a, page 5).
4. Connect the Refresh-o-mat to the power supply.
!
CAUTION! Health hazard
Do not breathe in the spray.
5. Press "START/STOP" once (fig. 9, page 4), to start the cleaning
procedure with 100 ml of fluid.
✔ The "READY/ON" LED lights up green.
I
NOTE
For a cleaning procedure with 400 ml of fluid press "START/
STOP" twice. All three LEDs flash briefly to confirm.
6. Ensure that the spray from the ventilation is sucked up.
7. The Refresh-o-mat stops automatically after approx. 20 minutes when
the fluid reaches a minimum level.
8. Press "START/STOP" once, to end the cleaning procedure prematurely.
9. Disconnect from the power supply.
10.Open all vehicle doors and allow the vehicle interior to air for approx.
30 minutes.
8

Maintaining and cleaning the device

A
NOTICE! Damage hazard
Do not use any sharp or hard objects for cleaning since they may
damage the device.
1. Disconnect from the power supply.
2. Remove the hose.
3. Empty any remaining fluid (fig. b, page 5).
4. Rinse out with water.
EN
Maintaining and cleaning the device
15