Aqara T2 User Manual

Aqara T2 User Manual

Dual relay module
Hide thumbs Also See for T2:

Advertisement

Product Introduction

Aqara Dual Relay Module T2 is a relay control module based on Zigbee wireless
communication protocol to control the power on and off of lights, fans and other
devices.This product can switch dry/wet node mode by connector wire. It also can realize
the functions of app remote control, timing control, power statistics, etc. with the hub;
HomeKit platform has been accessed, and the device can be quickly controlled through
the home app.
*This product needs to be used with a device that has Zigbee 3.0 hub function. Some
features require the support of specific model hubs, please check the detailed list at:
www.aqara.com/support.

Installation

*Make sure the mains is switched off before installation
Wet node mode(Access to the equipment is powered by the zero-fire line and the
equipment is controlled via relays)
1. Use a screwdriver to loosen the terminal block screws of the device and connect
the Connect the zero wire to the N hole, the fire wire to the L hole, use the connecting
wire to connect the LIN hole and LOUT hole, connect the load (lamp) wire to L1 and
L2.
2. If the user wishes to retain local control of the original switch, the wiring as shown
in the diagram below. Connect the common terminal of the external switch to the
COM hole, connect the switch control wires to S1 and S2, make sure the wiring is
Tighten the terminal screws once the wiring is correct.
3. Turn on the main power switch and add devices according to the quick setup.
4. Mechanical switch only available at AC 85V or above, no function for DC voltage.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the T2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Aqara T2

  • Page 1 Product Introduction Aqara Dual Relay Module T2 is a relay control module based on Zigbee wireless communication protocol to control the power on and off of lights, fans and other devices.This product can switch dry/wet node mode by connector wire. It also can realize the functions of app remote control, timing control, power statistics, etc.
  • Page 3 Dry node mode(Controlled devices are controlled by means of dry node signals) 1. Use a screwdriver to loosen the device terminal screws, connect the zero wire to hole N and the fire wire to hole L as shown in the diagram, connect the controlled dry node device to L1 and L2 and connect the COM terminal to the LOUT hole.
  • Page 4 Device Binding & Initialization 1. Before activating the accessory, please make sure you have the Aqara Home downloaded and Aqara hub installed. 2. Please open the app,"tap Home"and then tap"+"in the top right corner to enter"Add Device (Accessory)"page. Select"Dual Relay Module T2", and add it according to instructions.
  • Page 5 Warnings 1. This product is NOT a toy. Please keep children away from this product. 2. This product is designed for indoor use only. Do NOT use in humid environments or outdoors. 3. Beware of moisture, do NOT spill water or other liquids onto the product. 4.

Table of Contents

Save PDF