Programming The Water Softener; Setup Procedure - Viessmann VS 34 Owner's Manual

Programming the Water Softener

Display
OK / MENU

SETUP PROCEDURE

When the water softener is plugged in for the first time,
a beep sounds and the display briefly shows model
information. Next, a series of "wizard" screens prompts
you to enter basic operating information:
Language
English
Español
Français
1. LANGUAGE If the desired language already has a
black dot next to it (See Figure 19), go to Step 2.
Otherwise, press the softener's DOWN q or UP
buttons to scroll to the desired language, then press
the OK / MENU button to choose it.
2. Press the OK / MENU button to advance to the next
"wizard" screen.
Current time
3. CURRENT TIME Press the DOWN q or UP
tons to set the current time (See Figure 20). Hold
the button down to rapidly advance.
4. Press the OK / MENU button.
Hardness
430 PPM
5. HARDNESS Press the UP
set the value of your water's hardness (See Figure 21).
NOTE: Do not increase the hardness setting to
compensate for iron in your water. The
electronic control compensates automatically
after you set the iron level in Step 9.
LEFT UP RIGHT
Button Button Button
OK
DOWN
FIG. 18
Button Button
FIG. 19
18:45
FIG. 20
FIG. 21
or DOWN q buttons to
6. Press the OK / MENU button.
7. SALT LEVEL Press the UP
to set the salt level (See Figure 22). It should match
the lowest number visible on the brinewell above the
salt.
8. Press the OK / MENU button.
9. IRON LEVEL Press the UP
to set the value for iron in your water (See Figure 23).
10. Press the OK / MENU button. The screen will show
"Setup complete!" (See Figure 24).
but-
13. If, at this point, you want to go back and make
changes, press the DOWN q button to scroll to
Redo setup, then press the OK / MENU button
twice to repeat the "wizard" screens.
14. If no changes are desired, make sure Run softener
has a black dot next to it (See Figure 24) and press
the OK / MENU button. The unit begins normal
operation, described on the next page.
10
Salt level
3
or DOWN q buttons
Iron level
0.0 PPM
or DOWN q buttons
Setup complete!
Run softener
Redo setup
FIG. 22
FIG. 23
FIG. 24