Paia 9308 Assembly And Using Manual page 14

NN ~~ ww ver wer rm
"AG"
"AH"
"DG"
TO
R34-3 (s2)
R34-2 (s2)
R34-1 (s2)
R40-1 (s2)
R56-1 (s1)
R56-2 (s1)
R56-3 (s1)
R90-2 (s1)
R82-3 (s2)
R84-3 (s2)
R84-1 (s2)
R90-1 (s1)
R92-3 (s2)
R94-3 (s2)
R96-3 (s2)
R94-1 (s2)
R115-1 (s3)
R32-1 (s1)
S1-2 (s1)
FROM POINT
rm
Se a ete ee ee ee ~~ ew awa wa wwe was es es es es ess ss
R 3
The final connections are made using the wires from the wall-
mount power transformer PWR1. If this part has a connector on the end of
( ) Separate the power cord coming from PWR1 into two
wires for a distance of 2" ( 5-1/2" when installed in Desk
Top enclosure). Strip 1/4" of insulation from the ends.
Twist and tin the exposed wire strands.
( ) For rack panel installation pass the power cord through
the cable clamp and knot the cord so that the 2" wires
( ) In 9308C installation fit the 1/4" rubber grommet into
the hole provided for it as shown in fig 5. Pass the
power cord through the grommet and put a knot in
the cord 5-1/2" from the tinned ends.
( ) Connect and solder one of the wires from the power cord
to lug #2 of switch S4. The wires from the PWR1 are
interchangeable so either one can be used in this step.
14 FatMan MIDI Synth
TO
R69-2 (s1)
R114-1 (s1)
R114-3 (s2)
R74-3 (s2)
R74-2 (s1)
$3-2 (st)
R115-3 (s1)
R115-2 (s1)
$1-3 (s1)
R102-3 (s1)
R102-2 (s1)
R104-2 (s1)
R113-3 (s1)
$4-3 (s1)
R71-3 (s2)
R69-3 (s2)
R71-2 (s1)
DISCARD CONNECTOR
001015