Table of Contents
Advertisement
2.5.14 Guide Rail
{1) Take out 5 screws (A) and 1 screw (B).
{2) Disengage 4 claws and remove the guide rail.
Fig, 2-5-21
2-10
2.5.15 Stator Assembly
(1) Take out 2 screws {A).
(2) Raise the stator assembly in the direction indicated by
the arrow to remove it.
(3) Remove the flat cable.
(4) To reinstall, first secure the flat cable,then insert 2 screws
(A).
(5) After reinstating, be sure to perform PB switching point
adjustment(See SECTION
3 ELECTRICAL ADJUST-
MENT).
(A)
8 ,
THE FRONT SIDE
| |
a
Fiat Cable
THE FRONT SIDE
"FOIL SIDE
Fig. 2-5-22
NOTE : When refitting the connector, check that the flat wire
is inserted correctly.
2.5.16 Rotor Assembly
(1) Remove the stator assembly.
{2) Take out 2 screws (B) and remove the rotor assembly.
Fig.2-5-23
(3) Align the upper dum assembly and rotor assembly phase
as indicated in Fig.2-5-22.
(4) Overlap holes (a) of the upper drum assembly with holes
(b) of the rotor assembly {align holes in 3 locations) and
secure with 2 screws (B) as indicated in Fig.2-5-21.
~ ——- %:Hole not in straight
line toward the right
{b)
Fig. 2-5-24
2.5.17 Upper Drum Assembly
14. Removal
{1) Remove the stator assembly and rotor assembly.
(2) Use a 1.5 mm hexagonal wrench to loosen the collar
assembly screw and remove the collar assembly.
(3) Remove the upper drum assembly and use tweezers to
remove the Washer.
Collar Assembly
Washer ~ aly
Brush —an
fei!
"0 PS
| ae
| .
eh
Fig. 2-5-25
NOTE:
/f the Brush is replaced, do not apply the grease to
the contacts.
2. Installation
(1) Use an air brush to cloan the lawar drum aceambly and
the coil section of the new upper drum assembly.
(2) Set a new washer on the drum shaft as indicated in Fig.2-
5-25.
NOTE:
Be sure to use the new washer when replace the
upper drum assembly.
Fig.2-5-26
(3) Note the top and bottom of the collar assembly and de-
termine the position as indicated in Fig.2-5-25.
Fig.2-5-27
2-13
Advertisement
Table of Contents
