Wiring - HH MZ-C Series User Manual

WIRING

One or more wall controllers can be connected to the same MZ amplifier via an RJ45 standard CAT5
cable.
A single controller can manage up to 4 zones set via the DIP switch settings on the back, with multiple
controllers also able to control the same zone.
NOTE: Make sure that before connecting your wall controllers they are all set to the right zones they are
controlling.
To connect a single controller, use a standard CAT5 cable with RJ45 connectors. Plug one end into
the remote socket on the back of your MZ amplifier. Connect the other end to the socket on the wall
controller labelled IN (the left socket as you look at the back).
If multiple wall controllers are required, they must be connected in daisy chain formation from one to
the next. Do this by connecting the OUT of the previous controller to the IN of the next via an RJ45.
NOTE: Cables between wall controllers, or from wall controller to amplifier should not exceed a length of
100m.
When connected, turn on the amplifier and check that the mute LEDs on all connected controllers
turn on (either green or red). The led will flash while it is negotiating with the amplifier on power up
and will change to a solid colour once this is done.
Page 4