Advertisement
2. Alignment and Adjustment
2-1 Reference
1) X-Point (Tracking center) adjustment, "Head switching adjustment" and "NVRAM option setting" can be adjusted with remote control.
2) When replacing the M icom (IC601) and NVRAM (IC605 ; EEPROM ) be sure to adjust the "Head switching adjustment" and
"NVRAM option setting".
3) When replacing the cylinder ass'y, be sure to adjust the "X-Point" and "Head switching adjustment".
4) Among Samsung VCR remote control used for adjustment as a accessory, only the remote control that has figures buttons (0 ~9) is
available for all adjustment regardless of chassis.
5) How to adjustment.
- Press the "SW718 (TEST)" button on Main PCB to set the adjustment mode.
- If the corresponding adjustment button is pressed, the adjustment is performed automatically.
- If the adjustment is completed, be sure to turn the power off.
2-1-1 Location of adjustment button of remote control
EJECT
1®
@SHUTTLE@
X-Point (Tracking Center) Adjustment
("5" Button)
9 G U
D0
NVRAM Option Setting
("M ENU" Button)
Head Switching Adjustment
("SPEED" Button)
STANDBY/ON
DISPLAY
CNT.RESET SPEED
<This type of remote control can adjust.>
<This type of remote control can not adjust.>
Remote Control for adjustment is not supplied as a Service J ig.
Fig. 2-1
Samsung Electronics
2-1
Advertisement
