Table of Contents
Advertisement
Parts Overview
Metal Housing
Drip Tray
Drainpipe
After cleaning, you
can collect dirty water
from the Drainpipe
(there are two pipes.
One connects to the
evaporator. The other
connects to the Water
Tank under the Drawer).
Cooling Vents
Control Panel
Ice Drawer Handle
Transparent Window
View stored ice level
Ice Drawer
Water Tank
Hot Air Outlet
Water Drain Cap
Power Cord
6
Operation
CONTROL PANEL
"WATER
INDICATORS
SHORTAGE"
BUTTONS
"ICE"
PREPARING BEFORE USE
1. Remove the exterior and interior packaging and check if all the accessories are included.
If any part is missing, please contact Customer Service.
2. Clean the interior with warm water, diluted detergent, and a soft cloth.
See the "Cleaning and Maintenance" >
3. Place your Ice Maker on a dry, flat, and sturdy surface. Leave a clearance
of 6 inches (15 cm) on each side of the Ice Maker for proper ventilation.
4. Allow 24 hours for the refrigerant fluid to settle down before plugging in your Ice Maker.
5. Discard the first few batches of ice when using this appliance for the first time
or after an extended period of time.
6. The power plug must be easily accessible.
NOTE:
•
The Ice Maker should be far from direct sunlight and other sources of
heat (e.g.: stove, furnace, or radiator).
•
Some types of under-cabinet lamps can be hot enough to cause
damage to your appliance top's appearance.
"ICE
"POWER"
FULL"
"CLEAN"
"LIGHT"
Page
11.
7
Advertisement
Table of Contents
