Advertisement
B)
The ram is filled with oil and should only require occasional topping up. For the occasional top up DO NOT use brake fluid, as this
will damage the hydraulic seals. Proceed as follows:
1) Use only good quality hydraulic jack oil available from your Sealey stockist.
2) DO NOT OVERFILL as this will cause failure.
3) After filling with hydraulic oil, pump the crane up to its full height and pour off any excess oil.
6.2.
INSPECTION AND EXAMINATION OF CRANE BEFORE USE
A)
Before each use of the crane, perform an inspection for leaks, damage, loose or missing parts.
B)
The workshop crane must be examined immediately if it has been subject to an abnormal load or shock. It is recommended that
such an examination is made by an authorised service agent.
C)
The owner and/or operator must be aware that repair of this equipment will require specialised knowledge and facilities. It is
recommended that an annual examination of the workshop crane is made by an authorised service agent.
D)
Unauthorised parts may be dangerous and will invalidate the warranty.
6.3.
DEFINITION OF 'INSPECTION' AND 'EXAMINATION' BELOW
INSPECTION:
Inspect the crane for defects and check the operation of controls,
limiting and indicating devices without loading the crane. This check does not normally require any part of the crane to be dismantled
other than removal or opening of covers or housings.
EXAMINATION
Verification that the crane can safely continue in service including a functional test of all safety devices i.e. limiting, indicating
equipment, brakes, clutches, safety valves etc to verify that they operate within the required tolerances. An examination is
more thorough than an inspection.
6.4.
DAMAGED CRANES
Any crane which appears to be damaged, badly worn, or operates abnormally MUST BE REMOVED FROM SERVICE! It is
recommended that necessary repairs be made by an authorised service agent.
fig.4
Slewing
Handle
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product
becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and
dispose of the product and fluids according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
Pumping
Handle
sales@sealey.co.uk
Original Language Version
REGISTER YOUR
PURCHASE HERE
www.sealey.co.uk
SSC750 Issue 1 09/03/23
Advertisement
