Advertisement
● This manual is only for reference and does not
ensure that the information is totally consistent
with the actual product. For consistency, see the
actual product.
1. Package Contents
Open the package, check the appearance of the
product for no obvious damage, and confirm the
item list for table 1-1 is consistent.
Table 1-1: Packing List
Component
Mini Dome Network Camera
Setup & Support Insert
Installation Location Sticker
L Hexagonal Wrench 80×25mm
Stainless Self-Tapping Screw
PA4.0×30mm
Swell Plastic Button
φ5.6×29mm
2. Device Structure
Camera Dimensions
Note: Different devices may have different dimensions;
please refer to the actual product.
Figure 2-1: Dimensions of Dome (Units: mm)
3. Device Installation
Warning: To avoid moisture influence, install
the dome cover at least half an hour after the
camera is installed and powered on.
The Mini Dome Network Camera can be
installed on the ceiling or wall. This guide
describes how to install the camera on the
ceiling.
Installation Steps
1. Attach the installation sticker to the ceiling.
Drill three holes as indicated by the sticker.
Drive the swell buttons into the holes, as
shown in figure 3-1.
2. Use the wrench in the accessory package to
Quantity
unscrew the four screws on the dome cover.
Open the camera, as shown in figure 3-1.
1
1
1
1
2
2
3. Use the two self-tapping screws to fasten the
camera to the ceiling, as shown in figure 3-3.
4. Connect the network access port and power
supply of the multihead cable.
Note
The camera has two outlets for the cables. If using
●
the top outlet, a hole should be drilled for threading
the cable.
●
If using the side outlet, the installation sticker's gap
should align with the outlet rubber stopper.
Figure 3-1: Opening Camera
Figure 3-3: Installing Camera
Advertisement
