AEG IKE84475FB User Manual page 59

To set the heat setting use two left side
control bars.
Switching between the modes
To switch between the modes use sensor
field: .
When you switch between the modes the
heat setting is set back to 0.
Diameter and position of the cookware
Choose the mode applicable to the size and
the shape of the cookware. The cookware
should cover the selected area as much as
possible. Place the cookware centrally on the
selected area!
Place the cookware with the bottom diameter
smaller than 160 mm centrally on a single
section.
Place the cookware with the bottom diameter
larger then 160 mm centrally between two
sections.
100-160mm
6.2 FlexiBridge Standard mode
This mode is active when you activate the
hob. It connects the sections into two
separate cooking zones. You can set the heat
setting for each zone separately. Use two left
side control bars.
Correct cookware position:
Incorrect cookware position:
> 160 mm
ENGLISH 59