Table of Contents
Advertisement
2.5 Expansion Slots
Install an Expansion Card
You can install your expansion card by following steps:
1.
Read the related expansion card's instruction document before install the
expansion card into the computer.
2.
Remove your computer's chassis cover, screws and slot bracket from the
computer.
3.
Place a card in the expansion slot and press down on the card until it is
completely seated in the slot.
4.
Secure the card's metal bracket to the chassis back panel with a screw.
5.
Replace your computer's chassis cover.
6.
Power on the computer, if necessary, change BIOS settings for the
expansion card.
7.
Install related driver for the expansion card.
PEX16_1: PCI-Express Gen3 x16 Slot
-
PCI-Express 3.0 compliant.
-
Maximum theoretical realized bandwidth of 16GB/s simultaneously per
direction, for an aggregate of 32GB/s totally.
-
PCI-E 3.0 is supported by Core i7-3xxx / i5-3xxx CPU.
PEX1_1/ PEX1_2: PCI-Express Gen2 x1 Slot
-
PCI-Express 2.0 compliant.
Data transfer bandwidth up to 500MB/s per direction; 1GB/s in total.
-
-
PCI-Express supports a raw bit-rate of 5.0Gb/s on the data pins.
PCI1: Peripheral Component Interconnect Slot
This motherboard is equipped with 1 standard PCI slots. PCI stands for
Peripheral Component Interconnect, and it is a bus standard for expansion
cards. This PCI slot is designated as 32 bits.
H 6 1 M H P / H 6 1 M G P / H 6 1 M L P / H 6 1 M G P 2
11
Advertisement
Table of Contents
