Vectaire SFK10/4 Installation Instructions

attach the flexible ducting to the spigot of the out side wall grille and feed
the ducting through the hole from the outside until the grille is flush with the
soffit/wall. Fix the grille to the wall using the plugs and screws provided.
5. Pull the flexible ducting towards the fan, and ensuring that there is sufficient
ducting to stretch from the fan to the shower ceiling, cut the ducting and, using
a cable tie, fix to the extract side of the fan. Fix the other piece of ducting to
the intake side of the fan and stretch it gently to the spigot of the ceiling grille
again fixing with cable ties.
WIRING INSTRUCTIONS
1. Ensure that the mains electrical supply is switched off during the installation
of the fixed wiring spur.
2. Read carefully "Important-Electrical Information" above.
3. Connect as shown in the Wiring Diagrams below.
SFK 10/4, 12/5, 15/6
SFK 10/4T. 12/5T, 15/6T
Lamp
CLEANING & MAINTENANCE
1. Disconnect mains electrical supply by means of double pole switch.
2. To clean the inner part of the fan, use a soft brush taking care not to cause
any damage or disturb the electrical wiring.
Vectaire Ltd, Lincoln Road, Cressex Business Park, High Wycombe, Bucks, HP12 3RH
Tel: 01494 522333. Fax: 01494 522337. Email: sales@vectaire.co.uk
"SFK" - SHOWER FAN KIT
Installation Instructions
• for toilets, bathrooms and shower
cubicles
• three sizes
• with or without timer
• kit contains:
- in-line duct fan
- mounting bracket (4"/10cm version only)
- internal and external grilles
- 3m length of PVC flexible ducting (4"/10cm, 5"/12cm or
6"/15m diameter)
- screws, plugs and cable ties