Advertisement
UNiKA
User Manual
PRO IS2
GENERAL PRECAUTION BEFORE USE
Thank you for purchasing the UNiKA PRO SERIES AUDIO INTERFACE. Before using,
please read this manual carefully and pay attention to every detail that you must pay
attention to. If you use a mixer to connect to this interface, please turn off the mixer power
and +48V phantom power before connecting, and then turn on the power and phantom
power after inserting the signal cables. For passive models, please do not turn on the
phantom power to avoid leakage or damage the equipment.
If using a model with a volume knob, turn the volume knob to the minimum. During use,
please do not plug or unplug the wires arbitrarily to avoid signal loss. Please refer to the
following instructions for the soldering method of the plugs to ensure the expected level and
keep the signal smooth.
IIf you need further installation or operation guidance, please directly contact UNiKA's
dealer or distributor, or write to the following mail address for help:
info@unikapro.com
PRODUCT OVERVIEW
PRO IS2 is a passive two-input and two-output isolated signal splitter without the need to
install batteries or provide phantom power.
TM
PRO IS2 has a pair of built-in UNiKA-PRO
EI9AE3R3 1.25:1 isolation transformer with
special coating and surrounded by Oriental silicon steel shield which has a special copper
foil layer and a dedicated ground layer, which allows this device to restore high signal/noise
ratio and dynamic sound, and can avoid unnecessary Leakage caused by radio frequency
interference, ground interference and potential difference. PRO IS2 is particularly suitable
for recording studios, live performances and fixed installation projects.
PRO IS2's input uses Combi sockets, suitable for both balance XLR and TRS plugs. The
TM
CH-1/CH-2 output channels each have independent UNiKAPRO
isolation transformer and
independante GND/LIFT switch for easy connection to remote or different power sources
at the end of the equipment to eliminate the leakage and noise caused by the potential
difference and the ground loop.
CAUTION
This product has undergone rigorous inspection before leaving the factory. If customers encounter
failures during use, please contact your local dealer or distributor for replacement or repairing, do
not disassemble the case or replace parts by yourself, which will invalidate the warranty.
For details, please refer to the warranty regulations in the enclosed warranty card, and fill in the
details, and get a valid stamp or signature of the dealer or distributor.
1
Advertisement
