Pelonis PSHF2022EOC Owner's Manual page 7

OPERATION INSTRUCTIONS
Check Before Turning on the Machine
• Check if the power wire is under good condition.
• The product adopts 120V AC power supply, before use, please confirm if the rated
current of the power socket meets the local requirements with safe grounding device,
otherwise, please replace it with the qualified socket.
Put the Machine on the Flat Place
• Uneven place may possibly cause the turnover switch at abnormal position, then the
heater can't work after turning on, therefore, please put the heater on the flat place, at
least the surface below the base of the heater must be flat.
Temperature Control Knob
• Insert the plug into the power socket, then turn the Temperature Control knob
clockwise, when hearing the "poop" sound (it means the temperature controller is on),
adjust the Temperature Control knob to the desired temperature level.
Power Selection Knob
• Turn the Power selection knob to select between 4 functions: Low 900W(LOW), High
1500W(HIGH), Low 900W Swing (LOW SWING), High 1500W Swing (HIGH SWING).
Turn o the Heater
• Turn the Power selection knob to "0" position.
• Turn the Temperature Control knob anticlockwise to the initial position.
• Remove the power plug, store the heater after the entire machine has become cool.
Safety Protection
• Overheat protection: This heater is equipped with a temperature control component
for overheat protection that will be activated when the internal temperature exceeds
normal operating temperatures. If this occurs, turn the heater off, unplug it, inspect and
remove any objects on or adjacent to the heater. Allow it to cool for a few minutes,
and then plug it back in and resume normal operation.
• Inversion protection: When the whole heater is inverted, the safety system will
automatically cut off the power, and return to the work state before inversion after the
body is placed upright.
06