Gland Nut Torque Specification - APS 55K DIESEL HUSKY Operation And Maintenance Manual

Advanced pressure systems

Table of Contents



Torque all fittings to the manufacturer's specifications.



Follow the tubing manufacturer's recommendations for high-pressure tubing bending radii.



When pressurizing any new, rebuilt, or serviced high pressure components, remove all personnel

from the immediate area until the system pressure has been applied for three minutes and has

been cycled on and off at least three times. Gradually increase pressure [maximum of 1,379 bar

(20,000 psi) per minute].



High-pressure water may remain in the system for a prolonged period after closing the high-

pressure water source. Bleed the system pressure off before servicing any part of the pump.



Follow the manufacturer's recommendations for servicing the pump and use only original

manufacturer replacement parts.



Visually examine the entire system before placing it in operation. If any fault or malfunction,

correct it.

Tools



Use only approved test equipment. Examine the equipment regularly for correct operation and

calibration.



Use the correct tools for the job. Use of incorrect tools can result in injury to personnel or costly

damage to the equipment.



Remove all tools and rags from around the machine after servicing and before starting the

pump.



Use only approved work platforms. Never climb on or around the equipment on makeshift

devices.

Protective Clothing



Do not wear loose clothing while working around rotating parts of machinery.



Pressurized air can drive particles into eyes and skin if handled incorrectly. To prevent injury, use

appropriate protective equipment and clothing, and exercise extreme caution.



See Personal Protective Equipment (PPE) for more information.