AB Quality 2706-P4 Series Installation Instructions Manual page 12

6. Use a chain (not supplied) to hang the signs from the ceiling,
following the notes in Step 4 of Ceiling Mounting instructions on
page 9.
Back-to-Back Mounting
Remove only one end cap at a time for each sign.
TIP
1. Attach a mounting bracket on each end of the signs and replace
the end caps, following Steps 1 to 4 of the Wall mounting
instructions. However, replace only the bottom three screws for
each end cap. Torque the screws to 2.7 Nm (24 in-lb). Do this
step for each end of both signs.
Do NOT fasten the top screws to the end caps. The
TIP
top screws will be used to fasten the ceiling
mounting brackets to the end caps in the next step.
2. Attach ceiling mounting brackets to all the end caps following
Step 2 of the ceiling mounting instructions. Torque the screws to
2.7 Nm (24 in-lb).
3. Match the signs together back-to-back. Connect them together
following Steps 7 through 10 of the Wall Mounting instructions on
page 7.
InView Marquee Message Display
Do NOT fasten this screw to the end cap.
Fasten these three screws to each end cap.
Ceiling
mounting
bracket
Publication 2706-IN006E-EN-P
11