Film Loading.8 - Pentax ZOOM 280-P Operating Manual

2. FILM LOADING
(Ensure the power is off before inserting the film.)
1 Slide the back cover release lever down in
the direction of the arrow to open the back
cover as illustrated.
2 Place the film cartridge in the film chamber
by fitting its flat side on top of the rewind
shaft first and then slide the top end Into
the camera.
3 Pull the film leader out far enough from the
cartridge to reach the take-up spool
O-
Align the tip with the film leader end mark
Notes:
• Make sure not to touch the lens with your
fingers.
• Ensure the film is placed properly between
the guide rails 0.
• If there is dirt on the film detection section
O/ film cannot be wound properly.