Operation - HARDKORR HYPERION Series Instruction Manual

8

OPERATION

TURNING ON YOUR LIGHT BAR
The wiring harness included with your Hyperion Series light bar complies with Australian Design Rule
13/00 9.3.7. This means that it is designed to allow the light bar to illuminate only if the high beam head
lights are switched on.
The procedure to switch the light bar on is as follows:
• Switch on your vehicle.
• Switch on your headlights and activate high beam mode.
• Turn on the switch that is connected to your light bar wiring harness.
HIGH AND LOW BEAM MODES
Your Hyperion Series light bar incorporates high and low beam modes. The light bar has a memory
function so it will remember which mode you have selected even if the vehicle is switched off.
The procedure to switch between light modes is as follows:
• Ensure your headlights are switched on and set to high beam.
• Turn the light bar on using the switch, and then wait for at least two seconds.
• Turn the light bar on and off three times within five seconds. After doing so you should notice the
brightness of the light beam changes.