Realistic HTX-100 Owner's Manual page 18

Connecting to Power
1
Determine where you are going to connect the power
cable. If your boat has a fuse block, see Step 1 of
"Connecting to Power" under "Mobile Installation." If
your boat does not have a fuse block, you will connect
the power cable directly to the positive (+)terminal
on the battery.
2 Connect the bare end of the red wire to the point you
determined in Step 1 .
3 Connect the bare end of the black wire to an electrical
ground, such as the negative(-) terminal of the bat-
tery.
Plug the power cord's connector into the POWER
4
jack on the back of your transceiver.
Note: The power cord's connector and the POWER
jack are polarized, so the connector plugs in only one
way.
18
Warning: Do not connect power if you have not installed an
antenna. Transmitting without an antenna attached
damages the transceiver.
""
ii
Black
~~
-c:
--
-
~
~