JVC GR-DVL100U Manual page 10

18
Zoom in (T: Telephoto)
Zoom display
103
Zoom out (W: Wide angle)
Digital zoom
zone
10X (optical)
zoom zone
RECORDING Basic Recording (cont.)
FEATURE: Zooming
PURPOSE:
To produce the zoom irvout effect, or an instantaneous
change in image magnification.
OPERATION:
Zoom In
Slide the Power Zoom Lever towards "T'.
Zoom Out
Slide the Power Zoom Lever towards "W",
™ The further you slide the Power Zoom Lever, the
quicker the zoom action.
NOTES:
© Focusing may become unstable during Zooming. In
this case, set the zoom while in Record-Standby,
lock the focus by using the manual focus
(CF pg. 21), then zoom in or out in Record mode.
'© Zooming is possible to a maximum of 250X, or it
can be switched to 10X magnification using the
optical zoom (CF pg. 23).
@ Zoom magnification of over 10X is done through
Digital image processing, and is therefore called
Digital Zoom.
© During Digital zoom, the quality of image may
suffer.
© Digital zoom cannot be used when digital image
processing, such as Picture Wipe/Dissolve (7 pg.
26, 27) or Video Echo (F pg. 28), is activated.
© Macro shooting (as close as approx. 5 cm (2") to the
subject) is possible when the Power Zoom Lever is
set all the way to "W". Also see "TELE MACRO" in
the Menu Screen on page 24.
NOTE: Recording From The Middle Of A Tape
Time Code
During recording, a time code is recorded on the tape. This code is to confirm the location of the recorded
scene on the tape during playback,
If recording starts from a blank portion, the time code begins counting from "00:00:00"
(minute:second:irame, If recording starts from the end of a previously recorded scene, the time code
continues from the last time code number.
To perform Random Assemble Editing (F" pg. 44 - 49), time code is necessary. If during recording a blank
portion is left partway through the tape, the time code is interrupted. When recording is resumed, the time
code starts counting up again from "00:00:00". This means the camcorder may record the same time |__|
codes as those existing in a previously recorded scene. To prevent this, perform "Recording From The
Middle of A Tape" below in the following cases;
When shooting again after playing back a
recorded tape.
Display
«When power shuts off during shooting, Frames are not displayed
When a tape is removed and re-inserted during during recording.
shooting.
«When shooting using a partially recorded tape. Minutes
* When shooting on a blank portion located es
partway trough the tae, i Seconds
«When shooting a g a i n after shooting a scene |_Feames
then opening/closing the cassette holder cover. | ge sg:aaige (30 frames = 1 second)
Recording From The Middle Of A Tape
1. Play back a tape to find the spot at which you want to start recording, then engage the Stil Playback
mode (CF pg, 31).
2, Set the Power Switch to "3" or "1H" while pressing down the Lock Button located on the switch, then
start recording.
NOTES:
© The time code cannot be reset.
© During tast-forwarding and rewinding, the time code indication does not move smoothly.
© The time code is displayed only when "TIME CODE" is set to "ON" (© pg. 25, 32).
When a blank portion is recorded on a tape
Time code Time code Time code
00:00:00 05:43:21 00:00:00
Shooting start point Shooting stop point _ Shooting start point
Proper recording
Time code Time code Time code
00:00:00 05:43:21 05:44:00