Table of Contents
Advertisement
SETTING
Pass the tape through the space between the paper
After setting the feed spool on the left pin and the
meter (a) and the ribbon guide (b). Set the tape in
take-up spool on the right pin, turn the take-up spool
the tape guides on the left and right.
counterclockwise until the white tape winds around the
take-up spool.
Set the ribbon into the ribbon guides and then gently
Turn the ribbon feed knob counterclockwise to take up
press the cassette down until it clicks into place.
any slack. (To remove the cassette ribbon, simply
reverse this procedure.)
To prevent damage and ensure proper installation,
Press the motor lock lever toward the platen until it
always handle daisy wheels by gripping the clear plastic
clicks into place. Do not force the lever. If you have
tab of the cassette between the thumb and forefinger of
difficulty, check again to see that the daisy wheel
your right hand and insert the daisy wheel into the carrier.
is set properly.
Make sure that the daisy wheel slips all the way
down into place.
©
Advertisement
Table of Contents
