Ultrathin - Magnetic clip-on keyboard cover Know your product Ultrathin iK1061 Magnetic clip-on 带磁力夹的键盘盖 keyboard cover ® 50°-70° 10°-40° www.logitech.com/support/ultrathin-i6 1. Protective cover 7. Bluetooth and battery status light 2. Battery pull tag 8. Battery holder (two Lithium coin batteries pre-installed) 3.
Page 4
Ultrathin - Magnetic clip-on keyboard cover Set up your product ® 50°-70° 1. Pull out the battery tag. 3. Establish Bluetooth connection: • Your keyboard powers up. • On your iPad, make sure Bluetooth The status light shows solid green is on.
Ultrathin - Magnetic clip-on keyboard cover Hot keys Screen Shot Home = iPad Home screen Previous track Switch applications Play/Pause Siri® Use your voice to send messages, Next track make calls, schedule meetings, and more Mute Search Type keywords in the search bar for contacts, music, notes, events, Volume down mail, web, Wikipedia, and more...
Page 6
Ultrathin - Magnetic clip-on keyboard cover Use your product Status light indications Light Description Solid green Battery power is good (90%-100%). Solid red Battery power is low (less than 10%). Replace the batteries. Blinking blue Fast: The keyboard cover is in discovery mode, ready for pairing.
Page 7
Ultrathin - Magnetic clip-on keyboard cover Detaching your iPad 1. Pull back: Tilt your iPad backwards 3. Lift iPad: Lift your iPad out of until it is vertical: the Keyboard Cover vertically: 50°-70° 2. Push down: Apply downward pressure to ensure that the slot is completely flat: English 7...
Page 8
Ultrathin - Magnetic clip-on keyboard cover Attaching your iPad to the Keyboard Cover for travel 1. Slide your iPad towards the hinge at the Note: back of the Keyboard Cover. As your iPad • DO NOT try to slide your iPad into the hinge from the opposite direction: gets close to the rear hinge, it pops up: 10°-40°...
Page 9
Ultrathin - Magnetic clip-on keyboard cover Replacing your keyboard batteries 1. Place your Keyboard Cover face down 4. Close the battery holder: on a flat surface. 2. Using a fingernail or thumbnail, pry open the battery holder: Note: Your Keyboard Cover is provided with two Panasonic CR2032 3V 225mAh Lithium coin 3.
Ultrathin - Magnetic clip-on keyboard cover Troubleshooting The Keyboard Cover does not work My iPad doesn’t fit into the slot • Press any key to wake the Keyboard • Make sure you are inserting your iPad on Cover from sleep mode. its side into the slot, with the Home key on the right hand side.
Page 11
Go to: Connect with other users in our Community www.logitech.com/support/ultrathin-i6 Forums to get advice, ask questions, and share solutions. What do you think? Thank you for purchasing our product.
Page 12
带磁力夹的键盘盖 了解您的产品 Ultrathin Magnetic clip-on keyboard cover Ultrathin Magnetic clip-on keyboard cover For iPad™ English Replacing your keyboard batteries 1. Place your Keyboard Cover face down on ® a flat surface. 2. Using a fingernail or thumbnail, pry open the battery holder.