Information Codes - Samsung NX60 85 S Series User Manual

Troubleshooting
Problem Cause
Food does not The wrong cooking mode
bake or roast was selected.
properly in the
The oven racks have not
oven.
been positioned properly
for the foods being
cooked.
Incorrect cookware or
cookware of improper
size is being used.
The oven temperature
needs to be adjusted and
recalibrated.
There is aluminum foil
on racks and/or oven
bottom.
The clock or timers are
not set correctly.
Food does not The oven controls are not
broil properly in set properly.
the oven.
The oven door was not
closed during broiling.
The rack has not been
properly positioned.
48 English

Information codes

Action
See page 22.
Code symbol
See page 21.
See page 18.
See page 32.
Remove foil.
See pages 15
See page 24.
See page 24.
See the broiling guide on page
24.
** If these solutions do not solve the problem, contact a local Samsung service center.
Meaning
1. Press Apagar/Borrar (OFF/CLEAR),
Oven sensor malfunction.
and then restart the oven.
The oven is overheating.
2. If the problem persists, disconnect all
power to the oven range for at least
Check the Control PBA NTC
30 seconds and then reconnect the
Sensor.
power.
Check the PBA NTC Sensor.
Check the PBA NTC Sensor.
Control pad malfunction.
Door lock malfunction.
PCB signal malfunction.
Touch IC and PCB signal
malfunction.
1. If oven vent or cover air is blocked by
aluminum foil or others, remove that
and restart oven.
Oven vent blocked. 2. To reset error, disconnect power or
tap Apagar/Borrar (OFF/CLEAR) after
opening the oven door at least 60
seconds.
1. Disconnect power. Open the back cover.
Check there are signs of combustion in
the gas connection section.
Gas leakage in the gas 2. If there are signs of combustion, replace
connection section. GPR and TCO and check the gas leakage.
3. If there are no signs of combustion,
check wire-TCO, Wire main - sub
connection status and PBA S/W version.
Solution