Advertisement
Diagram #10
2 Pickups (1 EMG + 1-35-TW)
Toggle Style Select Switch
Push-Pull Pot as Master Volume
with a Master Tone (Passive)
Refer to Diagram #10 Above:
1) Install the Pickups and route the cables to the control cavity keeping
any excess cable under the pickup.
2) Choose an up/down option from Diagram #1 or #2 and plug the 35-TW
Pickup cable onto the push-pull pot.
3) Route a coax cable from the push/pull pot (H4) to the Pickup buss, Position 1.
Plug the pickup cable of the other EMG into Position 2 of the pickup buss.
4) Plug a coax cable from Position 3 of the Pickup Buss to the Tone control.
Plug a coax cable from the Tone control to the Push-Pull Pot (H1)
5) Plug the output cable from the Push-Pull Pot (H2) to the output jack and push
the connectors onto the T, S, and R terminals of the jack as shown.
6) Plug the RED Wires of the pickups onto the V+ Supply Buss (RED Shroud)
with the RED wire of the battery clip.
7) Strip the insulation from the switch wires and Insert them into the GREEN
and BLACK Terminal Blocks and tighten the screws with a small screwdriver.
Refer to the B157 Pickup buss instructions enclosed.
8) Put the battery in the insulating foam piece provided and place it securely in
the control cavity.
We suggest that you plug in the instrument and test it before closing the
control cavity.
Diagram #11
2 35-TW Pickups
2 Push-Pull Pots as Volume controls
(Volumes are independent)
2 Tones (Passive)
Toggle Style Switch
35-TW INSTRUCTIONS Page 4
- 9V +
GROUND
NECK P/U
OUTPUT
BRIDGE P/U
FROM NECK PICKUP
FROM 35-TW PICKUP
- 9V +
GROUND
NECK P/U
RED
OUTPUT
BRIDGE P/U
RED
FROM 35-TW PICKUP (NECK)
RED
FROM 35-TW PICKUP (BRIDGE)
RED
RED
RED
Refer to Diagram #11 Below:
1) Install the 35-TW Pickups and route the cables to the control cavity keeping
any excess cable under the pickup.
2) Choose an up/down option from Diagram #1 or #2 and plug the 35-TW Pickup
cables onto the push-pull switch sections.
3) Route a coax cable from each of the Push-Pull Pots (H1) to the Tone controls.
4) Plug a coax cable from the Bridge Tone to the Pickup Buss (Position 1)
Plug a coax cable from the Neck Tone to the Pickup Buss (Position 2)
5) Plug the output cable from the Pickup Buss (Position 3) to the output jack and
push the connectors onto the T, S, and R terminals of the jack as shown.
6) Plug the RED Wires of the pickups onto the V+ Supply Buss (RED Shroud)
with the RED wire of the battery clip.
7) Strip the insulation from the switch wires and Insert them into the GREEN
and BLACK Terminal Blocks and tighten the screws with a small screwdriver.
Refer to the B157 Pickup buss instructions enclosed.
8) Put the battery in the insulating foam piece provided and place it securely in
the control cavity.
We suggest that you plug in the instrument and test it before closing the
control cavity.
OUTPUT CABLE
NECK
VOLUME
BRIDGE
VOLUME
BATTERY
NEG (-)
MASTER TONE
R
S
MASTER
VOLUME
T
OUTPUT
OUTPUT CABLE
BATTERY
R
NEG (-)
S
T
OUTPUT
NECK TONE
BRIDGE TONE
Advertisement
