Endon EL-10047 Instruction Manual

Safety Warnings

This product is only suitable for connection to a 240V~50Hz supply in accordance with current IEE
wiring Regulations and should be installed in accordance with local Building Regulations and is for
Domestic indoor ceiling use only (it must be mounted out of arms reach) and is not suitable for a
Bathroom location.
This product should be connected to a lighting circuit protected by a 5 amp fuse (or a 6 amp
miniature circuit breaker).
If in doubt we recommend you contact a qualified electrician. Before installing your light fitting
always:
Switch off the mains supply and remove the appropriate fuse or switch off the appropriate circuit
breaker before commencing installation.
Ensure that no one else has access to the supply such that it could be inadvertently reconnected.
Never fit bulbs of a higher wattage or of a type other than those specified on the label as this may
cause overheating and damage the fitting.
The spot heads, and bulbs, become hot during use so please switch off and allow 10 minutes to cool
before replacing bulb, adjusting or cleaning.
This product contains glass parts – be careful during handling and maintenance to avoid breakage.
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
The "Minimum Distance" Label on the product – typical format shown below – indicates that lighted
objects should not be placed within the distance stipulated on the label. The example label below
indicates that lighted objects should not be placed within 0.5m (50cm) of the spotlight to prevent
them overheating.
If any modification is made it will invalidate the warranty and may render the product unsafe.
Please read these instructions carefully before fitting your new spotlight and retain for reference.
Make sure that there are no pipes or cables beneath the mounting surface.
Check the packaging and make sure that you have all the required parts.
Follow each assembly step in order to prevent incorrect assembly.
Make sure all screws / nuts, including electrical connections etc are fully tightened before use.
This type of Light Fitting may be connected to a Dimmer if a Tungsten incandescent bulb is used
(as supplied). If a CFL/LED type bulb is fitted then these cannot (generally) be controlled by a
dimmer.
The product contains spot light with
connection terminals and Gu10 bulbs.
The product contains spot light with
connection terminals and Gu10 bulbs.
EL-10047 (4 light Spotlight).
INSTRUCTION MANUAL
0.5m

Before you start

The following tools may be required:
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.