Endon Knight Spotlight Instruction Leaflet

Commissioning
• Replace the cover on the terminal block.
• Lift the product into place and align the screw holes up
with the holes on the bracket.
Fitting/replacing bulbs
• When changing a bulb, always switch off at the mains
and allow the bulb to cool before handling. Used bulbs
should not be disposed of with household waste. Please
recycle where facilities exist.
• Always use the correct type and wattage bulb. Using the
incorrect wattage bulb will damage the product.
• Use a soft cloth to handle bulbs, avoid directly touching
the bulbs as this will shorten their life.
• Unscrew the shades anticlockwise. Remove bulb by
turning a quarter turn anticlockwise and pulling out.
We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could
damage the finish.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Safety information
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
This bulb is protected by a glass shade. This part must be replaced immediately should the glass
shade become cracked or damaged. This fitting must not be used without the glass shade in place.
Replace Cracked Shade
• Using the supplied allen key, tighten the screws to
secure. Take care not to trap any wiring.
• Replace fuse or circuit breaker and switch on. Your light
is now ready for use.
• Push the bulb gently into the lampholder and twist a
quarter turn clockwise to engage pins. Replace the shade
by gently screwing on.
35W GU10
Mains Halogen
Glass parts – Wipe clean with a damp cloth. Do not use
abrasive materials as these will damage the finish.
Iss.3 13022017
Endon Lighting LS9 0SE
Instruction leaflet
Knight Spotlight
39166