Troubleshooting - Rosewill RHAA-11001HR User Manual

Home/RV Use Amplified Digital HDTV Antenna
nuts to fix the base on the pole.
(6) Perform the antenna connection methods as above (on page 2).
(7) Fix the main unit on the base.

Before the following step, please make sure that you have all protection you need when you
try to drill on wall and install the antenna outdoors or install the antenna to a vehicle.

Please note, when you use the electric drill, you should wear the eyes protection goggles,
and the drill bit must be fixed, to avoid any injury.
②. Wooden wall mounted installation
(1) Mark the fixing position
(please use the fixing
base to mark the
position).
(2) Take out the attached
screws. Use a screw
driver to fix these screws through the antenna fixing base and fix it on the wall.
(3) Attach the main unit to the antenna fixing base and fix it with screws (included).
③. Concrete or RC wall Mounted installation
(1) Take the electric drill, Use drill bit to drill a 35mm deep hole. Then clean the hole.
(2) Take the plastic screw anchors, using hammer to insert the anchors into the hole.
(3) Take the screws, use screw driver, and screw them through the fixing holder onto the
plastic anchors.
(4) Fix the main unit on the fixing holder.
Please note:

All the connection must be fixed, and it is strongly recommended that you should have a
water-drop loop at the end of the
cable before entering the
building.

After you complete the installation,
you can use your Set Top Box (or
Digital TV) to check the signal
strength and quality. If the quality is not good enough to have good pictures, you can move
the antenna to another location to get the better reception, and then fix it.
For the best reception, please check the following conditions:
1. Keep away from sources of interference: keep away from those large power consumption devices
such as air conditioner, elevator, hair dryer and microwave oven...etc.
2. Installed as high as possible: In the case of digital terrestrial reception, if there are some interruptions
between the antenna and transmission tower, it will cause the signal loss temporary. So installed the
antenna as high as possible to avoid the interruptions.
1. If you can not get the digital programs as you expect, please check the following conditions:
a. Check the connection. Make sure all the connection is correct.
b. Make sure the power inserter is connected correctly.
NOTICE
TROUBLE SHOOTING
4
RHAA-11001HR User Manual