Antenna Placement - Rosewill RHAA-11001HR User Manual

Home/RV Use Amplified Digital HDTV Antenna
Antenna Connection:
Powering the Antenna by a Power Adaptor
(1) Take out the RHAA-11001H main unit and fixing base.
(2) Take out the coaxial cable, through the fixing base, and connect it to the antenna.
(3) Place the fixing base to the main unit; fasten the screw and make sure the antenna is fixed. （4）
(4) Place the rubber cover on the connector between the cable and antenna. Make sure the
connector on the antenna is covered by the rubber cover.
Notice: If you need to use a longer coaxial cable for outdoor installation, please attach the rubber cover to
the cable.
(5) Follow one of the antenna placement instructions below
(6) Connect the other end of the coaxial cable to the power inserter.
(7) Connect another end of the power inserter to your Set-Top-Box (or Digital TV set).
(8) Take out the power adaptor, connect to the DC IN of the power inserter (the LED on the power
inserter will indicate the power status), and then connect the other end of the power adaptor to a
power outlet. Please use the provided power adaptor only.
(9) Turn on the power of STB and TV, and check for the signal.
Please note: All the connection must be fixed, and it is strongly recommended that you should have a
water-drop loop at the end of the cable.
Powered by a Power Adaptor
Power Adaptor
(AC 110V input)
STB or Digital TV

Antenna Placement:

①. Pole Mounted Application
(1) Prepare an antenna pole (mast).
(2) Take the pole mounting kits.
(3) Hook 2 U-type screws to the
pole.
(4) Attach the fixing base
through the U-type screws.
(5) Use 4 butterfly type screws
INSTALLATION
DC IN (12~24v)
Power Inserter (DC output 5V)
Indoor Outdoor
Coaxial Cable
3
RHAA-11001HR User Manual
Screw
Rubber cover
Water-Drop Loop
(Recommended)