Table of Contents
Advertisement
1
2. Place a suitable bowl below the drain
pump access to collect the water that
flows out.
3. Open the chute downwards. Always keep
a rag nearby to dry up any water spillages
when removing the filter.
4. Turn the filter 180 degrees in anti-
clockwise direction to open it, without
removing. Let the water flow out.
180˚
5. When the bowl is full of water, turn the
filter back and empty the container.
6. Repeat the steps 4 and 5 until the water
stops to flow out.
7. Turn the filter anti-clockwise to remove it.
2
1
8. If it is necessary, remove fluff and objects
from the filter recess.
9. Make sure that the impeller of the pump
can rotate. If it does not rotate, contact
the Authorised Service Centre.
10. Clean the filter under the water tap.
11. Put the filter back into the special guides
by turning it clockwise. Make sure that
you tighten the filter correctly to prevent
leakages.
2
ENGLISH
33
Advertisement
Table of Contents
