Table of Contents
Advertisement
energy consumption in a few cases, you may
need to activate the appliance again.
For more details, refer to Stand-by paragraph
in Daily Use chapter.
8.2 Introduction
The options/functions are not selectable
with all washing programmes. Check the
compatibility between options/functions
and washing programmes in the
"Programme Chart". An option/function
can exclude another one, in this case the
appliance doesn't allow you to set the
incompatible options/functions together.
Make sure the screen and touch buttons
are always clean and dry.
8.3 Temp. °C
When you select a washing programme, the
appliance automatically proposes a default
temperature.
Touch this button repeatedly until the desired
temperature value appears on the display.
When the display shows the indicators
and
, the appliance does not heat the
water.
8.4 Centrif.
When you set a programme, the appliance
automatically sets the default spin speed.
Touch repeatedly this button to:
• Decrease the spin speed.
The display shows only the spin
speeds available for the set
programme.
• Activate the Rinse Hold option.
The final spin is not performed. The water
of the last rinse is not drained out to
prevent the fabrics from creasing. The
washing programme ends with water in
the drum.
The display shows the indicator
door stays locked and the drum turns
regularly to reduce creasing. You must
drain the water to unlock the door.
If you touch the Inicio/Pausa
appliance performs the spinning phase
and drains the water.
The appliance empties the water out
automatically after 18 hours
approximately.
• Activate the Extra Silent option.
The intermediate and the final spinning
phases are suppressed and the
programme ends with water in the drum.
This helps to reduce creasing.
The display shows the indicator
door stays locked. The drum turns
regularly to reduce creasing. You must
drain the water to unlock the door.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are available. In
some programmes the rinses are
performed with more water.
If you touch the Inicio/Pausa
appliance performs the only draining
phase.
The appliance empties the water out
automatically after 18 hours
approximately.
8.5 Manchas/Pre-Lav.
Press this button repeatedly to activate one of
the two options.
The relevant indicator goes on in the display.
• Manchas
Select this option to add an anti-stain
phase to a programme in order to treat
heavily soiled or stained laundry with stain
remover.
Pour the stain remover into compartment
. The stain remover will be added in
the appropriate phase of the washing
programme.
. The
This option is not available with a
temperature lower than 40 °C.
button, the
. The
button, the
ENGLISH
15
Advertisement
Table of Contents
