Installation Instructions - Electrolux WS140SLMB User Manual

INSTALLATION INSTRUCTIONS

WARNING!
Read the "Safety Information" carefully for
your safety and correct operation of the
appliance before installing the appliance.
Before installation
Check that the input voltage indicated on
the characteristics plate is the same as the
voltage of the power outlet you are going to
use.
Open the drawer and take out all the
accessories and
material.
WARNING!
The front surface of the crockery heater may
be wrapped in a protective film. Before using
the crockery warmer for the first time, remove
this film carefully.
Make sure that the crockery warmer is not
damaged in any way. Check that the drawer
opens and closes correctly. If you find any
damage, contact the Technical Assistance
Service.
ATTENTION:
The power socket
accessible after the crockery warmer has
been installed.
The crockery warmer should only be built-in in
combination with those appliances indicated
by the manufacturer.
Installation
To build-in the
combination with another appliance there
must be a fixed, interim shelf in the housing
unit to support the weight of both appliances.
The appliance to be combined with the
crockery warmer will be placed directly on the
latter without any need to have a separating
shelf.
To build-in the appliance which is combined
with the crockery
instructions set
instructions and fitting booklet.
The relevant installation dimensions are
indicated in mm in the diagrams shown at
the end of this booklet. Proceed as follows:
remove the packing
should be
crockery warmer
warmer, follow
out in the respective
1. Place the crockery warmer on the shelf
and slide it towards the interior of the
niche in such a way that it is centred and
completely lined up with the front of the
unit.
2. Check that the crockery warmer's frame is
properly levelled and is sitting evenly on
the shelf.
3.
Open the drawer and fix the crockery
warmer to the sides of the unit using the
provided screws.
Electrical Connection
Electrical installation must be performed by an
electrician qualified in accordance with the
legislation in force.
Before connecting the crockery warmer to the
easily
electric mains, check that the voltage and
frequency of the mains matches that which is
shown on the rating plate located in the
heating block inside.
The electric connection is made via an
omnipolar switch, which is suitable for the
intensity to be tolerated and which has a
minimum gap of 3mm between its contacts,
which will ensure disconnection in case of
in
emergency or when cleaning the crockery
warmer.
If a plug is used for the electric connection,
then it must be accessible after installation.
The connection
earthing, in compliance with current norms.
WARNING:
The crockery warmer must be earthed.
the
The manufacturer and retailers do not
accept responsibility for any damage that
may be caused to people, animals or property
if these installation instructions are not
observed.
ENGLISH
should include correct
57