Table of Contents
Advertisement
No sound or only a very low -level sound is heard
f rom t he surround speakers.
, Make sure the sound field function is on (press
SOUND FIELD MODE).
, Select the appropriate center mode (see pages
25–27).
, Adjust the speaker volume (see page 18).
, Make sure the surround speaker size parameter is
set to either SMALL or LARGE (see page 16).
No sound is heard f rom t he sub w oof er.
, Make sure the sub woofer is set to YES (see page
17).
, Check that 2CH mode has not been selected (see
page 27).
Recording cannot be done.
, Check that the components are connected correctly.
, Select the source component with a FUNCTION
button.
, When recording from a digital component, make
sure the input mode is set to ANALOG (see page
23) before recording with a component connected
to the analog MD/TAPE terminals.
Radio st at ions cannot be t uned in.
, Check that the antennas are connected securely.
Adjust the antennas and connect an external
antenna if necessary.
, The signal strength of the stations is too weak
(when tuning in with automatic tuning). Use direct
tuning.
, Make sure you set the tuning interval correctly
(when tuning in AM stations with direct tuning)
(see pages 36 and 45).
, No stations have been preset or the preset stations
have been cleared (when tuning by scanning preset
stations). Preset the stations (see page 37).
, Press DISPLAY so that the frequency appears in
the display.
Downloaded from:
https://www.usersmanualguide.com/
The surround eff ect cannot be obt ained.
, Make sure the sound field function is on (press
SOUND FIELD MODE).
" PCM --kHz" appears on t he display.
, The sampling frequency is more than 48 kHz.
Change the input player setting to 48 kHz.
Not hing appears on t he display.
, When the display turns off immediately after the
receiver is turned on, press DIMMER to change the
display mode.
No pict ure or an unclear pict ure appears on t he
TV screen or m onit or.
, Select the appropriate function on the receiver.
, Set your TV to the appropriate input mode.
, Move your TV away from the audio components.
The rem ot e does not f unct ion.
, Point the remote at the remote sensor g on the
receiver.
, Remove any obstacles in the path between the
remote and the receiver.
, Replace both batteries in the remote with new
ones, if they are weak.
, Make sure you select the correct function on the
remote.
, If the remote is set to operate the TV only, use the
remote to select a source or component other than
TV before operating the receiver or other
component.
Ref erence sect ions f or clearing t he
receiver's m em ory
To clear
All memorized settings
Customized sound fields
See
page 14
page 32
43
Advertisement
Table of Contents
