Pioneer CLD-M450 Operating Instructions Manual page 12

CONNECTING TO YOUR STEREO AMPLIFIER
Connect the AUDIO OUT jacks of the player to the AUX,
CD, LD or VDP input jacks of your stereo amplifier.
NOTE:
@ Do not connect these terminals to your amplifier PHONO
input jacks.
Connecting to an optical digital jack
This unit can be connected to an amplifier equipped with an
optical digital jack.
1. Remove the protective dust cap from this unit's OPTICAL
DIGITAL OUT jack.
2. Use an optical fiber cable to connect OPTICAL DIGITAL
OUT jack of this unit to the optical digital input jack of the
amplifier.
@ Align the plug of the optical fiber cable with the optical
digital jack and fully insert the plug to make a secure
connection.
ere
©
To optical digital
input jack
eu awe mm a(t
@ Use a separately sold optical fiber cable for the optical
digital jack connections. However, when making optical
digital connections, the player can only be connected to
an amplifier which uses the same type of optical
transmission/reception module.
Precautions concerning use of optical fiber cables
@ Fully insert the optical fiber cable plugs all the way into
the jacks.
@ Be careful not to fold or crimp the cable. When coiling
an optical fiber cable for storage, make sure the diameter
of the coil is 15 cm (6 inch) or larger.
@ Use an optical fiber cable with a length of 3 m (10 feet}
or less.
@ Protect the optical fiber cable plugs from scratches and
dust.
@ When the unit is not connected using an optical fiber
cable, be sure to keep the protective dust cap plugged
into the optical digital output jack at all times.
(The illustration shows CLD-M450/CLD-M401.)
Stereo pmplisier 5906 O Remove the cap.
Optical fiber cable
bAadeletdadatadatateddalailelelakaielaka ta tatel ttt. ee ee
:
PLUG THE POWER CORDS INTO AC OUTLET
Plug the AC power cords of the player, stereo amplifier
and TV set into an AC outlet.
When the power cord of this unit is connected to an AC
outlet, power is supplied to the unit's internal memory
{such as the last memory) even when the POWER switch
is OFF. Therefore, be sure to connect the power cord
directly to a wali outlet. If the power cord is connected to
an outlet such as a switched outlet on an amplifier, the
various memory contents will be erased whenever the
amplifier's power switch is turned off.
(The illustration shows CLD-M450/
CLD-M401.)
AC outlet
12
<VRB1070>