Amana AIR COMMAND 80 Manual

a
AIR COMMAND 80
Model GUI
(U pf low)
GAS FIRED WARM AIR
FURNACE
installation
operation
INSTRUCTIONS
IMPORTANT TO THE INSTALLER
Before installing this unit please read this manual to
familiarize yourself on the specific items which must
be adhered to such as maximum external static pres-
sure to unit, air temperature rise, min. or max. cfm
and motor speed connections. Affix these Installation
Instructions adjacent to the furnace.
TO THE OWNER
It is important that you fill out the owner's registration
card and mail it today. When filling in the registration
card, be sure to include the Model, Manufacturing
and Serial Numbers, plus the installation date.
Your warranty certificate is also supplied with the unit.
Read the warranty carefully and note what is covered.
Keep the warranty certificate in a safe place, so you
can find it, if necessary.
If additional operating instructions are required, call
the dealer through whom the purchase was made.
Keep this literature in a safe place for future
reference.
A WARNING
Should overheating occur or the
gas supply fail to shut off, turn off
the manual gas control valve to the
furnace before shutting off the elec-
trical supply.
A WARNING
FOR YOUR SAFETY
Do not store or use gasoline or
other flammable vapors and liquids
in the vicinity of this or any other
appliance.
A
RECOGNIZE THIS SYMBOL AS A SAFETY PRECAUTION.
A
WARNING
Improper installation, adjustment, alteration, serv-
ice or maintenance can cause injury or property
damage or death. Refer to this manual. For
assistance or additional information consult a
qualified installer, service agency or the gas
supplier.
A
WARNING
FOR YOUR SAFETY
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from a neigh-
bor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the fire
department.
THE INSTALLATION AND SERVICING OF THIS EQUIPMENT SHOULD BE PERFORMED ONLY
BY QUALIFIED, EXPERIENCED TECHNICIANS.
Due to policy of continual product improvement, the right is reserved to change specifications and design without notice.
100266-8 Rev. 1