Before You Start; Switching On And Off; Device Not Starting - TomTom XL 325 User Manual

3.

Before you start

Before you start

Switching on and off

Install your TomTom XL navigation device in your car following the
instructions in the installation section at the start of this book.
To switch on your navigation device, press and hold the On/Off button until
you see the start-up screen. The first time you switch on your device, it may
take a short time to start.
To set up your device you need to answer a few questions by tapping the
screen.

Device not starting

In rare cases, your TomTom XL navigation device may not start correctly or
may stop responding to your taps.
First, check that the battery is properly charged. To charge the battery,
connect your device to the car charger. It can take up to 2 hours to fully charge
the battery.
If this does not solve the problem, you can reset the device. To do this, press
and hold the On/Off button for 15 seconds and release the button when your
device begins to restart.
Charging your TomTom XL
Before you use your XL for the first time, it's a good idea to charge it fully.
The battery in your TomTom XL navigation device charges when you connect
it to the car charger or to your computer.
There is no charging light on your XL. To check the battery status and see
when your XL is charging, switch on your device and tap the bottom right-
hand corner of the screen in the Driving View. The battery status is shown on
the next page.
When you connect your device to a computer, you are asked if you want to
connect to the computer. If you select No and then do not tap the screen
within three minutes, the device will automatically switch off. This happens so
that the battery can charge faster.
Note: You should plug the USB connector directly into a USB port on your
computer and not into a USB hub or USB port on a keyboard or monitor.
6