Advertisement
Quick Links
CONTENTS:
CONTENTS:
WARNING INFORMATION
OVERVIEW
..............................................................................................................................
OPERATION
.....................................................................................................................
TROUBLESHOOTING
DPI
...................................................................................................
..................................................................................................PAGES 8 - 10
USER
GUIDE
Rev.1.0
PAGE 2
PAGE 3
PAGES 4 -7
Advertisement
Related Manuals for TBC DPI1K
Summary of Contents for TBC DPI1K
- Page 1 USER GUIDE Rev.1.0 CONTENTS: CONTENTS: WARNING INFORMATION ....................PAGE 2 OVERVIEW ..........................PAGE 3 OPERATION ........................PAGES 4 -7 TROUBLESHOOTING ....................PAGES 8 - 10...
- Page 2 Failure to comply with instructions marked with the ”NOTICE” symbol may result in serious damage to the system or one of its components. Read all instructions before using this product. Important safety information on TBC products can be found under the following headings: ®...
- Page 3 PRODUCTS DPI1K DPI1C • Up/down drive • Up/down drive • Up to four favorite positions • Bluetooth ® • Display Desk Connect™ App NOTE: This user guide is only in reference to operation of the DPI controllers. For detailed assembly instructions,...
-
Page 4: Operation
OPERATION Operate the DPI by tilting it. 1. Tilt and hold up DPI to drive desk up, press and hold down DPI to drive desk down. 2. Release DPI when you have reached your requested position. Figure 1 Tilt and hold the DPI to drive the desk up Figure 2 Press and hold the DPI to drive the desk down DPI1C only: If favorite positions have been saved and automatic drive is enabled:... - Page 5 Settings mode (accessible via the DPI) The settings mode of the DPI1C is primarily meant for installers when installing the system, and for users who do not use the Desk Connect™ App. End users should not mix the ways to set up/configure the DPI but use either the Desk Connect™...
- Page 6 Units The second menu is ‘UNITS’. In this menu you can change the height unit. 1. Press the connect button to enter the menu. 2. Tilt the paddle up or down to scroll through the options ‘CM’, ‘MM’ and ‘INCH’. 3.
-
Page 7: Downloading The App
Limits The fourth menu is ‘LIMITS’. In this menu you can change the upper and lower desk height limits to prevent collision with for example a shelf above the desk or a cabinet placed under the desk. 1. Press the connect button to enter the menu. 2. -
Page 8: Troubleshooting
Glossary of Common Terms • Components » Desk leg (DL) – The lifting columns, typically with powder coated steel profiles, responsible for lifting the working load of the application. » Control box (CBD6S) – Both the computer and power supply of the system. »... - Page 9 STEP 1. Check under, above and on the sides of the desk for any obstructions that could prevent movement in either direction. The next two procedures (P4 and P5) are for a two leg desk system. The same concepts can be used for a three leg system using Channel 3 and so forth.
- Page 10 Symptom Procedure 1. Initialize the desk. If both legs begin to run down, complete the initialization. If only Desk is uneven one leg moves, stop and move to Step 2. 2. Check motor cable connections. Check to ensure motor cables are not pulled during movement.
- Page 11 NOTES: PAGE 11 (631) 293-4068 | support@tbcconsoles.com...
- Page 12 TBC Consoles is dedicated to product improvement and therefore reserves the right to make changes to the specifications of this and other products. © TBC Consoles. Not to be reproduced wholly or in part without specific written permission from TBC Consoles.