RAVEMEN TR50 - Wireless Rear Light, 50 Led Lumens Manual

Technical Specifications

LED: high efficient COB LED
Battery: 800mAh/3.7V rechargeable Lithium-ion battery
Dimensions (light unit): 19mm (L)*35mm (W)*65mm (H)
Weight (light unit): 41g
Package includes:
tail light *1,
base mount *1,
aero seatpost mount *1,
oversize seatpost connector *1,
large O ring *1,
small O ring *1,
USB cable *1,
silicone shim *1

Performance Parameters

Note: The above data are tested in Lab standard and may vary by environment and user conditions.

Quick Guide

1. Long press the button 0.5s to turn on/off power.
2. Single tap to cycle through modes.

Mode Memory circuit to remember the last used brightness level when on again.

Low battery indicator

When in low power, the light will switch to flashing mode automatically with the blue indicator light flashing, please charge your light soon.

Micro USB charging

Standard charging time: 2.5h with Max input: 5V, DC/450mA. (approximate values and may vary by user conditions). Built-in over-charge protection.
Note: the light cannot be turned on or used while charging.

Charging indicator

Flashing blue light during charging and constant blue light when charging completed.

Mounting Your Light

For round seatpost (φ24-32mm)

Stick silicone shim to the base mount and use the small O ring to fix to the seatpost.

For aero seatpost

Stick the aero seatpost mount to the base mount and use the large O ring to fix to the seatpost.

For oversize aero seatpost

Stick the aero seatpost mount to the base mount, then use the oversize seatpost connector and two O rings to connect the mount to the seatpost.

Make sure the light is mounted securely before riding.

Fix the base mount with the small O ring to the compatible helmet, then slide the light into the base mount; for some saddle bags or backpacks, the light could be attached to them directly

Safety

Attention

Make sure the light is mounted securely each time before riding.
Release the light from the bike while in the outdoors in case of theft.
To maintain the best performance and extending the life of the Li-polymer battery, it's recommended:

1. Check the battery and charge the battery up before your first riding.
2. Avoid completely discharging, allow partial discharges and avoid over charging (usually).
3. Keep and storage your light at room temperature.
4. Charge your light to 50% full every 3 months for long term storage.

Alert!
Don't disassemble or modify the light, otherwise it may cause danger and void your warranty.

Lithium-ion battery inside, don't put the light in a fire, otherwise it may cause explosion!

Please charge the light with qualified USB power adapter, using defective USB power adapter may cause power leakage or fire disaster, etc. Ravemen is not responsible for any of such consequences.

Web site: www.ravemen.com
Tel/Fax: +86-755-29064166
Email: service@ravemen.com

Documents / Resources

References

• RAVEMEN

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download RAVEMEN TR50 - Wireless Rear Light, 50 Led Lumens Manual