Sharp AQUOS sense6 Quick Start Manual page 40

• Do not leave the product wet. Doing so may let the liquids freeze on the
product in cold places or otherwise cause fault.
• Volumes may temporarily become lower due to water entering in the
earpiece (receiver), mouthpiece (microphone) and speaker. Drain water
and dry the product well before use.
• Do not place the product directly on sand at a beach, sandbox, etc. or on
mud. Grains of sand may get into the earpiece (receiver), mouthpiece
(microphone), speaker, sub microphone, earphone/microphone jack, etc.,
causing the volume to drop. If sand gets inside the product etc., it might
cause overheating or a fault.
• If the SIM card/microSD memory card tray degrades or is damaged, the
waterproof/dustproof property cannot be maintained.
• Do not drop or subject to impact. Also, do not jab the earpiece (receiver),
mouthpiece (microphone), speaker, sub microphone, etc. with a sharp
object. Doing so may cause damage or deformation to/of the product,
resulting in impairment of waterproof/dustproof property.
■ Precautions when using the product in a bathroom
• Do not let the product submerged into or get wet with hot water of a
bathtub or hot spring or water containing soap, detergent or bath powder.
Doing so might cause a fault.
If liquid other than tap water is attached on the product, you fall the product
into the bathtub, etc., immediately rinse the product in the specific
procedure and drain water or dry the product naturally.
• Use the product within 2 hours continuously in a bathroom where the range
of a temperature is 40°C or less, a humidity is 99% or less.
After that, be sure to drain water or dry the product naturally in the specific
procedure.
All function's continuous operations are not completely guaranteed.
• Take care not to get the product wet with high temperature water.
• The rapid changes of temperature may cause condensation.
Wait until the product reaches room temperature before you bring it from a
cold place into a warm bathroom etc.
Also, do not get the warmed product wet with cold water in a bathroom.
Doing so might cause water intrusion or a fault.
• If condensation occurs inside the camera lens or display, leave it in room
temperature until the condensation is removed.
- 39 -