Table of Contents
Advertisement
11.2 Troubleshooting
Problem
The tumble dryer is not connected to the
mains supply.
The door is open.
The tumble dryer
does not operate.
The On/Off button was not pushed.
The Start/Pause button was not touched.
The appliance is in standby mode.
Incorrect program selection.
The filter is clogged.
Dryness Level option was set to
dry .
The load was too large.
Unsatisfactory drying
result.
The airflow slots are clogged.
There is some dirt on the humidity sensor in
the drum.
The dryness level was not set to the desired
level.
The condenser is clogged.
The filter is not locked into position.
The loading door
Laundry is trapped between the door and
does not close
the seal.
It is not possible to
After a cycle starts it is not possible to
change the program
change the program or option.
or option.
It is not possible to
The option you tried to select is not availa‐
select an option. An
ble for the selected program.
acoustic signal is
emitted.
There is no drum
Defective drum lamp.
light
Unexpected duration
The drying duration is calculated according
time appears on the
to load size and dampness.
display.
The water container is full.
A program is inac‐
tive.
24
ENGLISH
Possible cause
3)
Connect it to the mains socket. Check the
fuse in the fuse box (domestic installation).
Close the door.
Push the On/Off button.
Touch the Start/Pause button.
Push the On/Off button.
Select a suitable program.
Clean the filter.
Change Dryness Level option to a higher
iron
level.
Do not exceed the maximum load size.
Clean the airflow slots at the bottom of the
appliance.
Clean the front surface of the drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct position.
Remove trapped items and close the door.
Turn the tumble dryer off and on. Change
the program or option as required.
Turn the tumble dryer off and on. Change
the program or option as required.
Contact the service centre to replace the
drum lamp.
This is automated - the appliance is working
correctly.
Drain the water container, push the Start/
2)
Pause button.
Remedy
1)
2)
4)
2)
Advertisement
Table of Contents
