Table of Contents
Advertisement
Service Manual
Model No.:
Note (1) No connection: These PINS are used only for the product of SAMSUNG.
(DO NOT CONNECT the input device to these pins.)
Note (2) Pin No. 1, 2, 3 are used only for I2C communication in flicker tuning.
(Refer to 9.5 Process Executing Guide)
Note (3) If set input is 8bit LVDS signal, Keep Echannel level '0'
Pin No.24 / Pin No.40 : Pull up(3.3V) with 1.5kohm resistor.
Pin No.25 / Pin No.41 : Pull down(GND) with 1.5kohm resistor.
Note (4) Pin number which starts from the left side.
a. Power GND pins should be connected to the LCD's metal chassis.
b. All power input pins should be connected together.
c. All NC pins should be separated from other signal or power.
Fig . The diagram of connector
Advertisement
Table of Contents
