Daylight Saving Time - Mitsubishi Electric Trane TAR-40MAAU Installation Manual

(3) Daylight saving time

The start/end time for daylight saving time can be set. The daylight saving
time function will be activated based on the setting contents.
• If a given system has a system controller, disable this setting to keep
the correct time.
• At the beginning and the end of daylight saving time, the timer may go
into action twice or not at all.
• This function will not work unless the clock has been set.
[Button operation]
1 The daylight saving time function can be activated/deactivated or the
start/end times can be set by using the F1 through F4 buttons.
• DST
Select "Yes" to activate the daylight saving time, or select "No" to
deactivate.
• Date(Start)
Set the start day of the week, week number, and month for daylight
saving time.
• Start time
Set the start time for daylight saving time.
• Forward to
Set the time when the clock is to be set forward to at the start time
above.
• Date(End) (2nd page)
Set the end day of the week, week number, and month for daylight
saving time.
• End time (2nd page)
Set the end time for daylight saving time.
• Backward to (2nd page)
Set the time when the clock is to be set backward to at the end time
above.
2 Press the SELECT button to save the setting.
* If "5th" is selected for the week number and the 5th week does not exist in the
selected month of the year, the setting is considered to be "4th."
(4) Administrator password setting
[Button operation]
1 A window to enter a new password will appear. Enter a new password,
and press the SELECT button.
2 Press the F4 button (OK) on the password change confirmation screen
to save the change. Press the F3 button (Cancel) to cancel the change.
Note: The initial administrator password is "0000." Change the default password
as necessary to prevent unauthorized access. Have the password
available for those who need it.
Note: If you forget your administrator password, you can initialize the password
to the default password "0000" by pressing and holding the F1 button for
ten seconds on the administrator password setting screen.
Note: The administrator password is required to make the settings for the
following items.
· Timer setting · Weekly timer setting · Energy-save setting
· Outdoor unit silent mode setting · Restriction setting
· Initial setting
Refer to the Instruction Book that came with the remote controller for the
detailed information about how to make the settings for these items.
– 17 –