Advertisement
4.2.
Refitting the rear crankshaft oil seal. fig.2.
4.2.1.
fit the new oil seal over the end of the crankshaft.
note: the central forcing screw is not required for installation.
4.2.2.
Place the VSE3038 against the seal, using the two bolts provided, secure the tool to the crankshaft boss and hand-tighten the fixing
bolts.
4.2.3.
using a suitable wrench, lightly and evenly tighten the two bolts to push the new seal into the housing until the machined lip of the
Vse3038 comes into contact with the housing, the lip is provided to ensure the new seal is correctly positioned.
note: Always ensure the central forcing screw and bolts are sufficiently
lubricated before use.
Parts support is available for this product. to obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
environmental Protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
imPortant: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
fig.3
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar
Original Language Version
fig.2
01284 757500
01284 703534
www.sealey.co.uk
sales@sealey.co.uk
Vse3038 | issue 1 19/01/17
Advertisement
